BTT Manta M4P+CB1

The Manta M4P control board and the CB1 core both are of the latest design which enables Hurakan to run Klipper while also supporting Marlin.

Klipper is Ready

Klipper (an improvement in 3D Printer firmware) has been pre-installed on the Hurakan, allowing you to leave out complicated installation procedures while enjoying speed, precision, and convenience.

Built-in WiFi Module

The built-in WiFi module makes it easier for users to print, pause, check printing progress, and adjust various printing parameters using the mainsail interface. Ensure that the control device and printer are connected to the same WiFi network.

BIQU MicroProbe, Auto Leveling

The self-developed auto-leveling sensor is tiny and lightweight at only 6g. It can be used over 10 million times while maintaining a high precision leveling capability.

Quiet 3D Printing

The Harakan uses an ultra-silent motor driver IC known as TMC2209 which significantly reduces printing noise.

Choose the Part to Heat

Adjust the heated area of the bed with a simple flick of a switch. Save energy and help protect the environment. 100W is for the central part of the bed (red light on). 240W is for the whole bed (both blue and red lights on).

Filament Runout Sensor

The filament runout sensor allows the printer to automatically pause a print if the filament runs out or breaks, therefore saving time and filament.

Venting Grille

The venting grilles situated on the base and print head add to the printer's unique look while serving the practical function of improving heat dissipation efficiency and reducing weight.

Light up Your Prints

An RBG light is fully customizable and beautifully designed to illuminate your prints in the dark, providing a full, 16.8M color control via the web interface or display screen.

Specification